Elektronik Delonghi Display PCB Firmwares

[badyl02]

I'm putting on the forum firmwares with various languages pack.
To read/write MCU and other devices I use Uprog programmer from RK-System. It is not cheap but very helpfull. Link: IC programmers Uprog - RK-SYSTEM

First it's from:
PCB p/n: 5513213091
MCU: R5F21258SNFP
EEPROM: 24C128 (empty: only FF)
Languages: German, French, Italian, English

 

[badyl02]

I'm putting on the forum firmwares with various languages pack.
To read/write MCU and other devices I use Uprog programmer from RK-System. It is not cheap but very helpfull. Link: IC programmers Uprog - RK-SYSTEM

First it's from:
PCB p/n: 5513213091
MCU: R5F21258SNFP
EEPROM: 24C128 (empty: only FF)
Languages: German, French, Italian, English
Anhang anzeigen 25959

EDIT: PCB have short 8 Pin connector

 

[badyl02]

ESAM 6700 EX: 2 PrimaDonna Avant
PCB p/n: 5513214871
MCU: R5F21258SNFP
EEPROM: 24C128 (empty: only FF)
Languages: German, French, Italian, English
PCB have short 8 Pin connector

 

[badyl02]

ESAM 6700 EX:2
PCB p/n: 5513215491
MCU: R5F21258SNFP
EEPROM: 24C128 (empty: only FF)
Languages: English, French, Italian, Dutch, Hungarian, Portuguese, Czech, Russian?, Polish, Fin,
PCB have short 8 Pin connector

 

[Ano]

Great, thanks!

Do you use an 8-pin connector on the pcb?
I far as I remember I connect to the 4-pin 'MICA' connector J8 (5V, MODE, RESET, GND) and to the 4-pin "Steckkonnektor" J9 (5V, Rx, Tx, GND). No 8 pin connector on the pcb...

Have you ever tried to do any reverse engineering on it?

 

[badyl02]

Yes I'm programming it from J8 connector


(sorry for quality)

8Pin connector I mean from display to main PCB

Have you ever tried to do any reverse engineering on it?

No I dont do this

 

[Ano]

Languages: English, French, Italian, Dutch, Hungarian, Portuguese, Czech, Russian?, Polish, Fin,

It contains 16 languages, as far as I know: English, French, Italian, Dutch, Hungarian, Spanish, Portugese, Russian, Czech, Polish, Finnish, Slovak, Bulgarian, Romanian, Norwegian, and Turkish.

 

[badyl02]

ESAM 6700 ATDE
PCB p/n: 5513214111
MCU: R5F21258SNFP
EEPROM: 24C128 (empty: only FF)
Languages:
PCB have short 8 Pin connector

 

[Repro]

Hallo, ich habe eine Frage. Ich kann keine Verbindung zum Display herstellen. Mit welcher Software liest du? Und Anschlussstecker - Verkabelung? Entschuldigung für Google Deutsch. Vielen Dank im Voraus für Ihre Antwort.

 

[badyl02]

Special programmer and software from Uprog. Link in first post. Elnec programmers supporting this chip also.

 

[Repro]

Vielen Dank.